Elica ESR436SS Manuel De Montage

ELECTRICAL GROUNDING INSTRUCTIONS

THIS  APPLIANCE  IS  FITTED  WITH  AN  ELECTRICAL  JUNCTION 

BOX WITH 3 WIRES, ONE OF WHICH (GREEN/YELLOW) SERVES 

TO GROUND THE APPLIANCE. TO PROTECT YOU AGAINST ELEC-

TRIC SHOCK, THE GREEN AND YELLOW WIRE MUST BE CON-

NECTED TO THE GROUNDING WIRE IN YOUR HOME ELECTRI-

CAL SYSTEM, AND IT MUST UNDER NO CIRCUMSTANCES BE 

CUT OR REMOVED

1.   Remove the knockout and the Junction box cover and install the   

conduit connector (cULus listed) in junction box.

A

E

B

F

C

D

A. White wires

B. Black wires

C. UL listed wire connector

D. Green (or bare) and yellow-

green ground wire

E. Home power supply cable

F. UL listed or CSA approved ½” strain relief

2.  Run  3  wires; black, white and green, according to the National 

   Electrical Code and local codes and ordinances, in 

1⁄2

” conduit 

      form service panel to junction box.

3.   Connect black wire from service panel to black or red in junction  

box, white to white and green to green yellow.        

4.   Close and secure junction box cover.

1.   Replace the two lateral supports

2.   Replace filters

3.   Check operation of the hood.

4.   If the range hood does not operate, check  to see whether a circuit

breaker has tripped or a household fuse has blown.  

Disconnect power supply and check that the wiring is correct.

Keep your Installation Instructions and Use and Care Guide close to 

range hood for easy reference.

1. Light control switch

2. Fan control switch

3. Lamp housings

4. Grease filter Handle

5. Grease filter

 

Fan Low/OFF/Hi

Ligth Low/OFF/Hi

Set light switch to OFF, LOW or HI intensity as needed.
FAN Control

Set fan switch to OFF, LOW or HI speed as needed.
ALWAYS USE THE HIGH SETTING WHEN GRILLING.