Speed Queen AWN432SP113TW04 Manuel De Montage

W329I_SVG

1. Beaded Strap (tape if necessary)
2. Standpipe Adapter

Figure 7

Laundry Tub Installation

For this type of installation, the drain hose MUST be secured to
the stationary tub to prevent hose from disloding during use. Re-
fer to Figure 8 . Use the beaded strap (supplied in accessories
bag) to secure hose.

We recommend leaving the standpipe adapter on the drain hose
for this type of installation.

W515I_SVG

1. Beaded Strap (tape if necessary)

Figure 8

Position and Level the Washer

1. Position washer so it has sufficient clearance for installation

and servicing.

2. Place washer in position on a clean, dry, and reasonably firm

floor. Installing the washer on any type of carpeting is not
recommended.

3. For easier access to leveling legs, prop up washer with a

wooden block.

TLW1977N_SVG

1. Wood Block

Figure 9

4. Place rubber cups (from accessories bag) on all four leveling

legs.

TLW1979N_SVG

1.   Level
2.   Locknut
3.   Leveling Leg
4.   Rubber Cup
5.   Washer Base

Figure 10

5. Place a level on the cabinet top and check if the washer is lev-

el from side to side and front to back.

6. If washer is not level, tilt washer back to access the front lev-

eling legs. Loosen the locknuts and adjust legs by screwing
into or out of washer base.

7. Once adjusted, tilt the washer forward on front legs and lower

back down into position to set the rear self-leveling legs.

8. Washer must not rock. When washer is level and does not

rock, tighten locknuts securely against bottom of washer base.
If these locknuts are not tight, washer will not remain station-
ary during operation.

Improper installation or flexing of weak floor will cause exces-
sive vibration.

Installation

Part No. 203174