Crossover WHWF09810M Manuel De Montage
Installing Crossover Washer OPL Liquid Supply Kit
CAUTION: THESE INSTRUCTIONS ARE INTENDED TO ASSIST QUALIFIED, EXPERIENCED
SERVICE PERSONNEL ONLY! IMPROPER SERVICING OF MACHINERY MAY RESULT IN
HAZARDOUS CONDITIONS, PERSONAL INJURY, OR DAMAGE TO PROPERTY. PERSONS
NOT TRAINED, OR PERSONS UNFAMILIAR WITH ELECTROLUX AND WASCOMAT
LAUNDRY MACHINES, SHOULD REFER SERVICING TO QUALIFIED PERSONNEL.
SERVICE PERSONNEL ONLY! IMPROPER SERVICING OF MACHINERY MAY RESULT IN
HAZARDOUS CONDITIONS, PERSONAL INJURY, OR DAMAGE TO PROPERTY. PERSONS
NOT TRAINED, OR PERSONS UNFAMILIAR WITH ELECTROLUX AND WASCOMAT
LAUNDRY MACHINES, SHOULD REFER SERVICING TO QUALIFIED PERSONNEL.
PARTS REQUIRED:
Kit 096445 containing:
3 barbed “L” fittings
2 Electrical fitting adapter washers
1 Trigger signal harness
1 Coin vault / card bay opening cover
INSTRUCTIONS:
1. Unplug washer from the electrical supply.
2. Remove the machine’s top panel.
3.
Support the soap dispenser housing and
carefully drill 1/8” pilot holes in the center
of those chemical ports on the top of the
dispenser (Fig. 1) that are intended for
use.
carefully drill 1/8” pilot holes in the center
of those chemical ports on the top of the
dispenser (Fig. 1) that are intended for
use.
4. Use a 13/32 or 10 mm bit to enlarge the
pilot holes that were drilled in step 3. (Fig.
1). Do not use other sizes of bits for this
step.
1). Do not use other sizes of bits for this
step.
PRELIMINARY
Technical Instructions TI 1127
Fig.1