Whirlpool WET4024EW Manuel De Montage
32
Level Washer/Dryer
IMPORTANT: Level washer/dryer properly to reduce excess
noise and vibration.
If washer/dryer is not level, prop up front of washer/dryer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer/dryer.
On 27" models, use a 9/16" or 14 mm open-end or adjustable
On 27" models, use a 9/16" or 14 mm open-end or adjustable
wrench to turn jam nuts clockwise on feet until they are
about 1/2" (13 mm) from the washer/dryer cabinet. Then
turn the leveling foot clockwise to lower the washer/dryer or
counterclockwise to raise the washer/dryer.
On 24" models, adjust the feet up or down as necessary.
On all models, remove wood block and lower washer/dryer.
On 24" models, adjust the feet up or down as necessary.
On all models, remove wood block and lower washer/dryer.
Recheck levelness of washer/dryer and repeat as needed.
With washer/dryer in its final location, place a level on top
edges of washer/dryer. Use side seam as a guide to check
levelness of sides. Check levelness of front using lid, as
shown. Rock washer/dryer back and forth to make sure all
four feet make solid contact with floor. If washer/dryer is level,
skip to step 3 (27" models) or step 4 (24" models).
1.
Check levelness of washer/dryer
Place level here
Place level here
2.
Adjust leveling feet (27" model shown)
Jam nut
Not Level
LEVEL
Not Level
When washer/dryer is level, use a 9/16" or 14 mm open-end
or adjustable wrench to turn jam nuts counterclockwise on
leveling feet tightly against washer/dryer cabinet.
HELPFUL TIP: You may want to prop washer/dryer with
HELPFUL TIP: You may want to prop washer/dryer with
a wooden block.
3.
Tighten leveling feet (27" models)
Jam nut
4.
Plug into a grounded 3- or 4- prong
outlet
In U.S.A.