Whirlpool WET4024EW Manuel De Montage

Complete Installation Checklist

q

   Check that all parts are now installed. If there is an extra 

part, go back through the steps to see which step was 

skipped.

q

   Check that you have all of your tools.

q

   Dispose of/recycle all packaging materials. Keep the plastic 

foam for use if the washer/dryer should be transported.

q

   Check the washer/dryer’s final location. Be sure the vent is 

not crushed or kinked.

q

   Check that the washer/dryer is level and front leveling feet 

are tight. See “Level Washer/Dryer.”

 

  

q

   For power supply cord installation, plug into a grounded 

outlet. For direct wire installation, turn on power.

  

q

  Plug into a grounded 4-prong outlet. Turn on power.

 

q

  Check that the water faucets are on.

 

q

  Check for leaks around faucets and inlet hoses.

 

q

   Remove the protective film on the console and any tape 

remaining on the washer/dryer.

 

q

  Read the Washer/Dryer Use and Care Guide.

 

q

   Wipe the dryer drum interior thoroughly with a damp cloth  

to remove any dust.

 

q

   To test the washer, measure 1/2 the normal recommended 

amount of detergent and pour it into the washer. Close the 

lid. Select HEAVY and pull out the Cycle Control knob. Allow 

the washer to complete one whole cycle.

 

q

   To test the dryer, set the dryer on a full heat cycle (not an air 

cycle) for 20 minutes and start the dryer.

 

 

• Controls are set in a running or “On” position.

 

• PUSH TO START button has been firmly pushed.

 

• Washer/dryer is plugged into a grounded outlet.

 

• Electrical supply is connected.

 

•  Household fuses are intact and tight, or circuit breakers 

have not tripped.

 

• Dryer door is closed.

 

q

   When the dryer has been running for 5 minutes, open the 

dryer door and feel for heat.

 

 

•  There may be 2 household fuses or circuit breakers for the 

dryer. Check that both fuses are intact and tight, or that 

both circuit breakers have not tripped. If there is still no 

heat, contact a qualified technician.

NOTE: You may notice an odor when dryer is first heated. This 

odor is common when the heating element is first used. The odor 

will go away.