GE GTW810SPJMC Manuel Du Propriétaire

3

„ Turn off water faucets to minimize leakage if a break or 

rupture should occur. Check the condition of the fill hoses; 

GE recommends changing the hoses every 5 years.

„ Ensure that the hot water hose is connected to the “H” 

valve and the cold water hose is connected to the “C” 

valve.

„ Install or store where it will not be exposed to 

temperatures below freezing or exposed to the weather, 

which could cause permanent damage and invalidate the 

warranty.

„ Properly ground washer to conform with all  

governing codes and ordinances. Follow details  

in Installation Instructions.

„ Optional drain hose extension recommended for 

discharging heights from 60” - 96”.

„ This washer does not include water supply hoses.

  GE strongly recommends the use of factory specified 

parts. A list of factory hoses available for purchase are 

listed. These hoses are manufactured and tested to meet 

GE specifications.

  GE strongly recommends the use of new water supply 

hoses. Hoses degrade over time and need to be replaced 

every 5 years to reduce the risk of hose failures and water 

damage. 

Parts and Accessories
Order on-line at GEApplianceparts.com today, 24 hours a 

day or by phone at 800.626.2002 during normal business 

hours. In Canada, visit your local GE parts distributor or call 

800.661.1616.
Part Number 

PM14X10002 

4 ft rubber water supply hoses

Or
PM14X10005 

4 ft braided water supply hoses

WH49X301 

Drain hose extension

DR07X10005 

6’ Cable - CleanSpeak™ communication

PBX10W00Y0 

WiFi ConnectPlus module

„ If the lid is opened between cycles (i.e. not pausing and 

restarting the current cycle, changing cycles after it 

started, etc.) pushing the Start button will cause the 

washer to turn on the cold water for 5 seconds followed 

by a 10 second delay before locking the lid and starting 

the cycle.

„ If the lid is opened during this 15 second period, the word 

PAUSE will start scrolling across its display. You will have 

to push the Start button again to restart the cycle.

Plug into a grounded 3 prong outlet.
DO NOT remove ground prong.
DO NOT use an adapter.
DO NOT use an extension cord.
Failure to follow these instructions can result in death 

or electrical shock.