GE GTW810SPJMC Manuel Du Propriétaire

4

A

B

Press to “wake up” the display. If the display is active, press to put the washer into idle mode.

NOTE: Pressing Power does not disconnect the appliance from the power supply.

Press Start to begin the cycle. NOTE: The lid must be closed for the washer to fill and the cycle to start. If the lid is open, “LID” will scroll across 

the display. If the lid is closed, the lid will lock, the detergent will be dispensed, and “FILL” will scroll across the display.
Pressing Start again will Pause the cycle and the Start indicator light will blink.
To continue the cycle, press Start again. If machine is paused more than 24 hours, the cycle will be cancelled. If water remains in the machine, 

select the Drain & Spin cycle to drain basket and spin water out of the washer basket.

Display and Status Lights

Display:
The display shows the approximate time remaining until the end of the cycle. 
NOTE: The cycle time is affected by how long it takes the washer to fill. This depends on the water pressure in your home. The “smart” timer 

“learns” the amount of time it takes to fill your washer and adjusts the total time accordingly.
In addition, this display will, “scroll” the washer status:

Start of rebalancing cycle to redistribute clothes. Stops after rebalancing is complete.

‡CyCLE PrEP Sensing 

dry load size prior to fill (normal).

When Delay Wash is initiated. Replaced with estimated time when cycle starts.

End of current cycle.

For the first 45 seconds of a fill, the estimated end of cycle time is displayed. For the rest of the fill time, “FILL” is scrolled  

 

 

until the fill completes.

‡H2O SUPPLY   Can not sense water level (valves possibly turned off).
‡LId  

Cycle stopped because lid is open. Close the lid.

‡LOAd SenSE Sensing 

wet load size (normal). 

Cycle paused because the Start/Pause button was pressed and the washer was set to Pause. Press Start button again to  

 

 

 restart the cycle.

Cycle status lights:
Shows whether the washer is in the SOAK, WASH, RINSE or SPIN cycle.
Feature status lights indicate (see sections F and * for more details):

                   The washer is locked - will blink once if you press any button or turn the cycle knob.

                 A delay wash time is set.

           The washer controls are locked.

C

B

A

F

G

D

C

E