Samsung RS27FDBTNSR Guide D’Installation Rapide

•  When transporting and installing the appliance,care should be taken to ensure that no parts of the refrigerating

circuit are damaged.

•  R-600a or R-134a is used as a refrigerant.

Check the co mpressor label on the rear of the appliance or the rating label inside the refrigerator to see which
refrigerant is used for your refrigerator.

•  Do not install this appliance near a heater, inflammable material.
•  Do not spray inflammable gas near the refrigerator.

- There is a risk of explosion or fire.
•  Do not install this appliance in a humid, oily or dusty location, in a location exposed to direct sunlight and water (rain

drops).

- Exposure can cause insulation to deteriorate. Deteriorated insulation on electrical parts may cause electric shock or

fire.

•  Do not place this refrigerator in direct sunlight or expose to the heat from stoves, room heaters or other appliances.
•  Do not plug several appliances into the same multiple power board.

The refrigerator should always be plugged into its own individual electrical outlet which has a voltage rating that
matched the rating plate.

- This provides the best performance and also prevents overloading house wiring circuits, which could cause a fire

hazard from overheated wires.

•  If the wall socket is loose, do not insert the power plug.

- There is a risk of electric shock or fire.
•  Do not use a cord that shows cracks or abrasion damage along its length or at either end.
•  Do not bend the power cord excessively or place heavy articles on it.
•  Do not use aerosols near the refrigerator.

- Aerosols used near the refrigerator may cause an explosion or fire.
•  Do not install this appliance in a location where gas may leak.

- This may result in an electric shock or fire.

•  We strongly recommend you use a qualified technician or service company to install or service the refrigerator.

- Failing to do so may result in an electric shock, fire, explosion, problems with the product, or injury.
•  This refrigerator must be properly installed and located in accordance with the manual before it is used.
•  Connect the power plug in proper position with the cord hanging down.

- If you connect the power plug upside down, wire can get cut off and a cause fire or an electric shock.
•  Make sure that the power plug is not squashed or damaged by the back of the refrigerator.
•  When moving the refrigerator, be careful not to roll over or damage the power cord.

- This constitutes a fire hazard.
•  The appliance must be positioned so that the plug is accessible after installation.