Samsung RF26J7500 Utilisation Et Entretien

Page de 120
English - 22
Removing any residual matter inside the 
water supply line after installing the water 
filter.
1.  Turn ON the the water supply if you turned it off 
when you installed the water filter.
2.  Run water through the dispenser until the water 
runs clear (approx. 6 to 7 minutes). 
This will clean the water supply system and 
remove air from the lines.
3.  Additional flushing may be required in some 
households. 
4.  Open the Refrigerator door and make sure 
there are no water leaks coming from the water 
filter.
Be sure to flush the dispenser thoroughly, 
otherwise water may drip from the 
dispenser. 
This means that there is still air in the line.
Reverse Osmosis Water Supply 
IMPORTANT:
The pressure of the water supply coming out of a 
reverse osmosis system going to the water inlet 
valve of the refrigerator needs to be between 35 
and 120 psi. (241 and 827 kPa) 
If a reverse osmosis water filtration system is 
connected to your cold water supply, the water 
pressure to the reverse osmosis system needs to 
be a minimum of 40 to 60 psi. (276 to 414 kPa) 
If the water pressure to the reverse osmosis 
system is less than 40 to 60 psi (276 to 414 kPa):
•  Check if the sediment filter in the reverse 
osmosis system is blocked. 
Replace the filter if necessary.
•  Allow the storage tank on the reverse osmosis 
system to refill after heavy usage.
•  If your refrigerator has a water filter, it may 
further reduce the water pressure when used 
in conjunction with a reverse osmosis system. 
Remove the water filter.
If you have questions about your water pressure, 
call a licensed, qualified plumber.
DA68-02601D-00.indb   22
14. 11. 24.   �� 11:08