Elica ENM230 Manuel De Montage

NOTE: The 3¹⁄4” x 10” (8.3 x 25.4 cm) rectangular vent  

connector can be installed up to 1” (2.5 cm) on either side of

the hood center to accommodate off center ductwork. 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

If a vent damper is installed with a wall cap with damper, 

  check to make sure they do not interfere with each other. 

 Remove the vent connector damper flap if they interfere.

Non-ducted (recirculating) installations - No vent 

  attachments. The ERS230, ENM230 and ENM236 series 

  models requires the removal of the recirculation cover plate. 

  Remove the two screws from the recirculation cover plate and 

  remove.

■

■

A. Screws
B. Recirculation cover plate

A

B

Power Supply Cable Installation 

For direct wire installations, run the home power supply cable 

  according to the National Electric Code or CSA standards 

  and local codes and ordinances. There must be enough 

 wiring from the fused disconnect (or circuit breaker) box to 

  make the connection in the hood electrical terminal box. 

  For optional power supply cord kit installations, follow the 

  instructions included with the power supply cord kit. 

 

NOTE: Do not reconnect power until the installation is 

  complete.

Remove the screw from the terminal box cover. Remove 

  terminal box cover and set aside. 

 

 

 

 

 

 

 

 

 

 

 

 

Remove the power supply knockout from the top or rear of 

 the vent hood (depending on the incoming location of your 

 home power supply cable) and install a UL Listed or CSA 

 approved ¹⁄

” strain relief. 

 

 

 

 

 

 

 

 

 

 

 

Using 2 or more people, lift the hood into final position. Feed 

  enough electrical wire through the ½” UL listed or CSA 

  approved strain relief to make connections in the terminal 

  box. Tighten the strain relief screws.

Position the range hood so that the large end of the keyhole 

  slots are over the mounting screws. Then push the hood 

  toward the wall so that the screws are in the neck of the slots. 

  Tighten the mounting screws, making sure the screws are in 

  the narrow neck of slots.

Connect ventwork to hood. Seal joints with clamps to make 

  secure and airtight.

Check that back draft dampers work properly.

A. Terminal box cover
B. Screw

A

B

A. Power supply knockout

A

B

A

B

D

C

Vertical connector
6.5 x 9.5 mm screws
Vent knockouts
Horizontal connector

A.
B.
C.
D.

A

B