Whirlpool UXT4236ADW Manuel De Montage

5. Mark Hole Locations 

Lift the range hood into place and insert the mounting bracket 
tabs through the slots in the back of the range hood. 

Hold the range hood firmly in place with one hand and bend each 
mounting tab (A) upward approximately 90°.

Mark the hole at the power supply knockout (B).

For a non-vented (recirculating) installation: Go to Step 7.

For a top vented installation: Mark the 4 vent hole locations (C) 
on the top of the range hood.

For a rear vented installation: Mark the 4 vent hole locations (D) 
on the rear of the range hood.

OPTIONAL: Mark the hole in each mounting tab.

Remove the range hood and set it aside.

6. Mark and Cut Vent Opening 

■

Using a 

¹⁄₂" (13 mm) drill bit, drill a hole in each of the dots 

marked previously on either the wall or upper cabinet. Using 
the outside edges of the holes, mark the vent opening.

■

Using a jigsaw or keyhole saw, cut the vent opening.

■

Using the 7" (17.8 cm) round vent mounting plate, draw the 
vent opening outline on the underside of the cabinet:

-

Place the vent mounting plate on the bottom of the 
cabinet. Position the edge of the plate with the widest 
distance (A) between the hole and edge of the mounting 
plate against the wall. Position the side edges of the 
mounting plate between the dots marked previously.

IMPORTANT: The widest edge (A) of the vent mounting 
plate must be positioned against the wall.

-

Trace the 7" (17.8 cm) vent opening (solid line) on the 
cabinet bottom.

■

Using a jigsaw or keyhole saw, cut the vent opening 1" 
(2.5 cm) larger than the 7" (17.8 cm) hole traced (dashed line).

45˚+

A

B

C

C

D

D

A

A