Whirlpool WEG730H0DB Manuel De Montage

1. Remove the oven racks and the oven door. See the “Oven 

Door” section.

2. Remove 2 screws and washers at the rear of the oven 

bottom. 

3. Lift the rear of the oven bottom up and back until the front of 

the panel is away from the front frame. Remove from oven 
and set it aside on a covered surface.

4. Remove 2 screws from the bake burner.

5. Slide the front of the bake burner to the side to remove tab 

from front of oven. Lift the back of the bake burner off the 
oven orifice, and set the bake burner aside. Do not 
disconnect the wire.

6. Apply masking tape to the end of a 

³⁄₈" (1 cm) nut driver to 

help hold the gas orifice spud in the nut driver while changing 
it. Press nut driver down onto the gas orifice spud and 
remove by turning the LP gas bake burner orifice spud 
counterclockwise to remove. The spud will be stamped with a 
“56.”

7. Replace the “56” spud with a “47” spud. Install the Natural 

gas bake burner orifice spud, turning it clockwise until snug.

IMPORTANT: Do not overtighten.

8. Position the back of the bake burner over the oven orifice, 

and align the holes for the screws.

9. Reattach the bake burner with 2 screws.

10. Position the front of the oven bottom panel toward the front 

frame and lower the rear of the oven bottom panel into the 
oven.

11. Reattach the oven bottom panel with 2 screws and 

2 washers.

1. Remove 1 screw from the broil burner.

2. Remove the flame spreader.

3. Remove the broil burner from the broil burner orifice hood.

NOTE: The broil burner will hang in the back of the oven while 
you are changing the orifice hood.

A

B

A

B

A

A

C

D

A

B