Whirlpool WEG730H0DB Manuel De Montage

1. Light burner and turn to lowest setting where both inner and 

outer burners are lit.

2. Remove the control knob.

3. Insert a 

¹⁄₈" (3 mm) flat-blade screwdriver into the adjustment 

locations shown in the following illustration and engage the 
slotted screw. Turn the screw until the flame is the proper 
size. Turning the screw clockwise will increase the flame size, 
and turning the screw counterclockwise will decrease the 
flame size.

4. Replace the control knob.

5. Test the flame by turning the control from the low position to 

the high position, checking the flame at each setting.

Refer to the User Guide for proper operation of the oven controls. 

1. Remove the premium storage drawer, warming drawer or 

baking drawer (see the “Remove/Replace Drawer” section).

2. Locate gas pressure regulator at rear of the drawer 

compartment.

NOTE: On models with a warming drawer or baking drawer, 
an access cover must be removed to access the gas 
pressure regulator.

IMPORTANT: Do not remove the gas pressure regulator.

3. Check the oven bake burner for proper flame. 

a. Remove the oven racks. 

b. To remove the oven bottom: Remove 2 screws at the rear 

of the oven bottom. Lift the rear of the oven bottom up 
and back until the front of the panel is away from the front 
frame. Remove from oven and place on a covered 
surface.

c. Press BAKE.

d. Press the start pad. 

The oven bake burner should light within 8 seconds. Under 
certain conditions, it may take the burner up to 50 to 
60 seconds to light. 

Electronic igniters are used to light the bake and broil 
burners.

This flame should have a ½" (1.3 cm) long inner cone of 
bluish-green, with an outer mantle of dark blue, and should 
be clean and soft in character. No yellow tips, blowing or 
lifting of flame should occur.

4. If the oven bake flame needs to be adjusted, locate the air 

shutter near the center rear of the drawer cavity behind the 
access panel. Loosen the locking screw and rotate the air 
shutter until the proper flame appears. Tighten locking screw.

5. Push the off pad when finished. 

6. Reinstall the oven bottom and the premium storage drawer, 

warming drawer or baking drawer (see the “Remove/Replace 
Drawer” section).

A

B

C

A

A

B

A

B