ADC Campus-REX2 RS Manuel D’Utilisation

Gently press the card into place until it is seated firmly in the mating 
connector.

Secure the card in place using the two captive screws.

Install a Campus-RS line unit and connect it to an HDSL line using the 
Campus-RS Line Unit User Manual. The line unit provides the DSL 
connection for the interface card.

The 10 Base-T and 100 Base-Tx (10/100Base-T) port on the rear panel of the 
Campus-REX2 connects to a LAN through a hub, repeater, or another router. 
The port autosenses both the 10/100Base-T port rate and half- or full-duplex 
mode of the network device to which it connects and matches the 
configuration.

Use a straight-through Category 5 cable to connect the Ethernet port. Set the 
MDI/MDI-X switch to the appropriate position, dependent on the device to 
which you are connecting.

Set the Campus-REX2 MDI/MDI-X switch to one of the following:

MDI-X when connecting to 
network equipment such as 
an Ethernet NIC in a PC or 
any other equipment that has 
an MDI port

MDI when connecting to 
network equipment such as a 
hub, switch, or router or any other equipment that has an 
MDI-X port

Use when connecting
to an MDI port such as
a PC Ethernet NIC

Use when connecting
to an MDI-X port such as
a hub, switch, or router

MDI-X

MDI