Hitachi VHS VT-M292A Manuel D’Utilisation

Getting Started (Controls) 

 

19

GUIDE  Brings up an on-screen setup and programming guide, the Easy Guide System. 

DISPLAY  Used in on-screen programming and indexing. 

CLEAR  Used in on-screen programming and indexing. 

VCR/TV  Switches between viewing through the VCR and not viewing through the VCR. 

VOLUME  Increase or decrease the audio volume. 

MUTE  Turns off the audio until you press MUTE again. 

REW  Rewinds the videotape. 

PLAY  Starts playing a loaded cassette. 

REC  Starts recording on the station the VCR is set to.  

VCR, TV (MODE SELECT) Device buttons let you set the remote to control one of the 
two devices. 

0 to 9  Number buttons used in on-screen programming.  Can also be used to change 
channels.  (Simply press 2 or 3 digits for the channel you want--such as 0 and 6 for 
channel 6, or 100/ENT and 2 and 4 for channel 124.) 

AVX  Used for recording from an auxiliary input such as a stereo system. 

CHANNEL  Top button switches to next higher channel, bottom button switches to the 
next lower channel.  For these to operate, you must have preset your channels. 

LAST CHANNEL  Switches to the TV channel you watched previously during the 
current viewing session. 

F.FWD  Fast forwards the videotape. 

STOP  Stops a videocassette from playing, recording, pausing, rewinding--or anything it 
is doing. 

PAUSE   Temporarily stops the cassette from recording or playing. Press PAUSE again 
(or PLAY) to resume. 

Check out these possibilities: 

Low Battery 
If the remote is not working even at close range, try putting in two fresh AA batteries. 

 When replacing the batteries, remove the old batteries and press the POWER button 

on the remote and hold it for about 10 seconds, then insert two fresh batteries. 

Objects in the Way 
There may be objects between the remote and the VCR--for instance, a stack of books