Furuno GP32 Manuel D’Utilisation

8. MAINTENANCE & TROUBLESHOOTING 

The satellite monitor display shows 
information about GPS and GEO satellites. 
 
1.  Press the [MENU] key once or twice to 

open the menu. 

2. Choose SATELLITE. 
3.  Press the [ENT] key. 

Number, bearing and elevation angle of 
all GPS and GEO satellites (if applicable) 
in view of your receiver appear. Satellites 
being used in fixing position are displayed 
in reverse video; satellites not being used 
are shown in normal video. 

D3D

DOP
1. 5

DOP value

Satellite number in reverse
video is used for positioning.

Altitude

North

Receiver
status
(See page 2.)

Receive signal level
Bars show signal level.
Satellites whose signal
level extends past the
dashed line are used
in fixing position.

85m

Elevation 5

°

Elevation
45

°

GEO satellite

GEO
satellite

W

 

4.  Press the [MENU] key twice to quit the 

SATELLITE display. 

 
 

The diagnostic test checks ROM, RAM, data 
port, beacon receiver, battery, RTC, keyboard 
and LCD for proper operation. 
 
1.  Press the [MENU] key once or twice to 

open the menu. 

2.  Choose SYS SETUP and then press the 

[ENT] key. 

3.  Choose “TEST?” and then press the 

[ENT] key. You are asked if you are ready 
to start the test. 

YES         

 

4. Press ◄ to choose YES and then press 

the [ENT] key to start the test. 

5.  The equipment tests ROM, RAM, data 

port, beacon receiver, internal battery and 
RTC. The results are individually 
displayed as OK or NG (No Good). 

XX = Program version no.

 

 BEACON test result shown as 

NONE when no beacon receiver is 
connected to the GP-32. 

 DATA2 requires a special 

connector to check. “- -” appears as the 
result when no connector is connected. 

 No program number shown for 

BEACON in case of the GP-32. 

 CNT shows the number of times 

the test has been executed consecutively.