Nilfisk-Advance America SR 5110 P/B Manuel D’Utilisation

 

S31NUK5120(3)2001-04

 

Insert the ignition key into the panel and turn it 
clockwise: the display will show all zeros and after 
about three seconds the battery voltage will appear.

 

: the temporary lighting of the two side brush 

indicators and the short sound from the reverse 
speed acoustic indicator are to be considered a 
normal behaviour.

Wait not less than three seconds before restarting the 
machine after switching Off.

Check the charge status of the batteries on the 
display.
Six different data/functions can be shown on the 
display.

The six functions are described in the following table

 

.

 

:

- to pass to the next function press the yellow display 

button once, 10 seconds after choosing one of the 
possible data/functions 

- the display will return automatically to the battery 

voltage from every function 

- data 2 and 3 will increase just using the traction 

function (accelerator pedal) 

- data 4, 5 and 6 will increase only if main broom is 

turning AND traction function is used 

- when datum 5 is displayed you can reset it just by 

keeping the yellow display button pressed 5 
seconds.

- If the batteries are charged enough, now it is 

possible to start the job (in battery mode).

If the machine is equipped with the gasoline engine, 
proceed with the start of the engine itself.

 

To start the gasoline engine press the red button 
shown in the figure; to stop the engine press the 
same button again.

 

: the battery voltage is normally shown on the 

display. A block function will be activated in case of battery 
undervoltage: when battery voltage will be about 20V all 
machine functions will stop, except traction; in this case the 
display will show 0205; proceed then with a battery recharge 
(see Maintenance paragraph)

Normally fixed.

(battery voltage)

Flashing when 

0205 appears.

 

: to read the machine working time - in 

hours - press once the yellow display button. By pressing the 
button a second time the working minutes will appear. Just 
waiting ten seconds the display will show the battery voltage 
again

Fixed

 

: the displayed value will increase 

each 1000 m

 

2

 

Fixed

 

: the displayed value will increase 

each 10 m

 

2

 

Fixed

 

: sweeping rate m

 

2

 

/hour: it depends on the 

instantaneous machine working speed

Flashing