3com WX1200 3CRWX120695A Manuel D’Utilisation
730
C
HAPTER
24: B
OOT
P
ROMPT
C
OMMANDS
Access — Boot prompt.
History —Introduced in MSS Version 3.0.
Usage — To display the system image software versions, use the fver
command. This command does not list the boot code versions. To display
the boot code versions, use the version command.
command. This command does not list the boot code versions. To display
the boot code versions, use the version command.
Examples — The following command displays all the boot code and
system image files on a WX switch:
system image files on a WX switch:
boot> dir
Internal Compact Flash Directory (Primary):
WXA30001.Rel
8863722 bytes
Internal Compact Flash Directory (Secondary):
WXA30001.Rel
8862885 bytes
See Also
display
Displays the currently active boot profile. A boot profile is a set of
parameters that a WX switch uses to control the boot process. Each boot
profile contains the following parameters:
parameters that a WX switch uses to control the boot process. Each boot
profile contains the following parameters:
Boot type — Either compact flash (local device on the WX switch) or
network (TFTP)
network (TFTP)
Boot device — Location of the system image file
Filename — System image file
Flags — Number representing the bit settings of boot flags to pass to
the booted system image.
the booted system image.
Options — String up to 128 bytes of boot options to pass to the
booted system image
booted system image