Regency IG35-NG Manuel D’Utilisation

Regency IG35 Gas Inbuilt Fireplace

6)  Place the ECS manual control switch key pad on the outside of the 

opening in the faceplate and the control switch to the inside of the 
faceplate.

 

Align the holes and secure in place using the 2 bolts, washers, 
phenolic spacers, split lock washers and nuts. See diagram 3 for 
sequence. Diagram 4 shows ECS manual control switch mounted 
on faceplate.

7)  Run the thermodisc wires thru the hole in the heat shield.  

      Then place the grommet over the sleeve and tuck into the hole in the 

heat shield as shown in diagram 5.

1)  Unplug the power source.

2)  Remove the glass door.

Diagram 1

Diagram 5

4)  Unplug the CAT5 cable from the ECS manual switch included with 

the unit. See diagram 2.

5)  Remove the 2 bolts, washers, phenolic spacers, split lock washers 

and nuts securing the manual control switch to separate the manual 
control switch keypad. See diagram 2.

Diagram 2

Diagram 3

Diagram 4

3)  Remove the heat shield from the left side of the faceplate by undoing 

the 2 screws. See diagram 1.