Regency IG35-NG Manuel D’Utilisation

Regency IG35 Gas Inbuilt Fireplace

11)  Place the cable ties thru the cable tie holders in the heat shield loosely 

to secure loose wires.

 

Run the CAT5 cable from the unit thru the cable ties on the heat 
shield and tighten cable ties. Ensure not to overtighten. Cut excess 
cable tie. See diagram 8.

Diagram 8

12) Partially mount the heat shield to the left side of the faceplace and 

connect the CAT5 cable to the ECS manual control switch. See 
diagram 9.

Diagram 9

13) Secure the heat shield to the faceplate using 2 screws. See diagram 

10. NOTE: Screws are secured from the front. 

Diagram 10

9)  Bring faceplate close to unit.

10) Run thermodisc wires from top of heat defl ector through
       left side of faceplate.  See Diagram 7.

Diagram 7

8)  Secure with 2 Phillips Head Screws as shown. 
      See Diagram 6 inset

Diagram 6