Standard Horizon PS1000 Manuel D’Utilisation
Page 45
Phantom PS1000
3
Select type of reply function “
SEND
” or “
NO REPLY
”
by using the [
] or [] key.
4. W h e n “
S E N D
” i s s e l e c t e d , p r e s s t h e
[CALL(SET)MENU] key. And your position will be
transmitted to the requesting vessel.
transmitted to the requesting vessel.
5. To exit from position request display, press the [16/9] key.
11.9 POSITION SEND
The feature is similar to Position Request, however instead of requesting a
position of another vessel this function allows you to send your position to an-
other vessel. Your vessel must have an operating GPS receiver connected for
the Phantom PS1000 to send the position.
position of another vessel this function allows you to send your position to an-
other vessel. Your vessel must have an operating GPS receiver connected for
the Phantom PS1000 to send the position.
11.9.1 Setting up a Position Send Ringer
The PS1000 has the capability to turn off the Position Send ringer.
1. Press and hold down the [CALL(SET)MENU] key
1. Press and hold down the [CALL(SET)MENU] key
until “
RADIO SETUP
” menu appears.
2. Press the [
] key to select “
DCS SETUP
” menu,
then press the [CALL(SET)MENU] key.
3. Press the [
] or [] key to select “
DSC BEEP
” menu,
then press the [CALL(SET)MENU] key.
4. Press the [
] or [] key to select “
POS SEND
”
menu, then press the [CALL(SET)MENU] key.
5. Press the [
] or [] key to select “
oF
.”
6. Press the [CALL(SET)MENU] key to store the se-
lected setting.
7. To exit this menu and return to radio operation mode
press the [16/9] key.
If you wish to return to enabling the ringer tone, just repeat the above proce-
dure, pressing the [
dure, pressing the [
] or [] key to select “
on
” in step “5” above.
11.9.2 Transmitting a DSC Position Send Call
1. Press the [CALL(SET)MENU] key. The DSC Op-
eration menu will appear.
2. Press the [
] or [] key to select “
POS SEND
” menu,
then press the [CALL(SET)MENU] key. The trans-
ceiver will beep, and the “Position Send directory”
will appear. (To cancel, press the [16/9] key)
ceiver will beep, and the “Position Send directory”
will appear. (To cancel, press the [16/9] key)
3. Press the [
] or [] key to select the “name” you
want to contact.
4. Press the [CALL(SET)MENU] key to send your position
to the selected vessel.