Gaggenau AW 230 790 Manuel D’Utilisation

▯

The walls must be smooth, vertical, and 
sufficiently load-bearing.

▯

The depth of the bore holes must be the same 
length as the screws. The wall plugs must have a 
secure grip.

▯

The enclosed screws and wall plugs are suitable 
for solid brickwork. Suitable fasteners must be 
used for other structures (e.g. plasterboard, 
porous concrete, poroton bricks).

▯

The max. weight of the extractor hood is 

.

9

Risk of electric shock
Parts inside the appliance can have sharp 
edges. The connection cable can be damaged. 
Do not bend or pinch connection cables during 
installation.

The necessary connection information is located on 
the identification plate in the appliance interior, 
remove metal grease filter to access it.

This appliance meets EC radio interference 
suppression requirements.

9

Risk of electric shock
It must always be possible to disconnect the 
appliance from the electricity supply. The 
appliance must only be connected to a 
protective contact socket that has been 
installed correctly. If the plug is no longer 
accessible following installation of the 
appliance, or a fixed connection is required, an 
all-pole isolating switch must be present on the 
installation side with a contact gap of at least 3 
mm. The fixed connection may only be installed 
by an electrician.

9

Ensure that there are no electric wires, gas or 
water pipes in the area where holes are to be 
made.

Mark a vertical center line on the wall from the 
ceiling to the lower edge of the extractor hood.

Mark positions for the screws and the contour of 
the attachment area.

Drill five 

5

/

16

" (8 mm) Ø holes to a depth of 3 

5

/

32

" 

(80 mm) for the attachments and press in the wall 
plugs flush with the wall. 

[

PP