Gaggenau AW 230 790 Manuel D’Utilisation

Press the safety caps with the arrow upwards 
onto the brackets until they engage. 

®

Screw on knurled nut and washer firmly. 

¯

If the safety caps have to be removed, use a flat 
screwdriver.

Note: If an aluminum pipe is used, smooth the 
connection area beforehand.

Attach exhaust-air pipe directly to the air-pipe 
connector and seal.

Attach reducing connector directly to the air-pipe 
connector.

Attach exhaust air pipe to the reducing connector. 

Seal both joints appropriately.

9

Risk of injury
From sharp edges during installation. Always 
wear protective gloves while installing the 
appliance.

Separate the flue ducts. 
To do this, remove the adhesive tape.

Remove the protective foil from both flue ducts.

Push one flue duct into the other.

‒ To prevent scratches, lay paper over the edges 

of the lower flue duct to protect the surface.

‒ The slots of the inner flue duct point 

downwards.

Place flue ducts on the appliance.

Push the inner flue duct upwards and attach it to 
the angle brackets on the left and right. 

¨

Press the flue duct downwards until it engages. 

©

Screw the flue duct to the sides of the angle 
bracket using two screws. 

ª

Loosen the flue duct.

Disconnect the appliance from the power supply.

Loosen the exhaust air lines.

Loosen screws for fastening the appliance.

Remove the appliance.

)

*

[

$

%

&