Kobe Range Hoods CH7930SQB Manuel D’Utilisation
9
UNDER THE CABINET INSTALLATION – REAR VENT
Preparation before installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE
VENT OPENING.
-
Decide the location of the venting pipe from the hood to the outside. Refer to Figure 6.
-
A straight, short venting run will allow the hood to perform more efficiently.
-
Try to avoid as many transitions, elbows, and long run as possible. This may reduce
the performance of the hood.
the performance of the hood.
-
Temporarily wire the hood to test for proper operation before installing.
-
Peel protective film off the hood (if any).
-
For installing under the cabinet with recessed bottom, attach 4-inch wide wood filler
strips (not included) on each side. Refer to Figure 7.
strips (not included) on each side. Refer to Figure 7.
-
Measure and create access opening for electrical wires under the cabinet or access
opening for the electrical wires at the rear of the hood.
opening for the electrical wires at the rear of the hood.
-
Remove the screws on the vent cover (rear) and cut along the line of the inner vent
cover (rear) opening. Refer to Figure 8.
cover (rear) opening. Refer to Figure 8.
-
Cut the vent cover (rear) opening and reverse to the other side. Refer to Figure 9.
Reattach the vent cover (rear).
Reattach the vent cover (rear).
Figure 6 Figure 7
Inner
Vent
Reversed
Cover (Rear) Vent Cover
(Rear)
(Rear)
Figure 8 Figure 9