GE MNU099 Manuel D’Utilisation

(continued)

.

The oven door is
removable,  but it is
heavy. You may need help
removing and replacing
the 

door. 

Do not lift the

door by the handle. This
can 

 the glass to

break or can cause
damage   the door.
To remove the door,
open it a few inches to the special stop position that

will hold the door open. Grasp firmly on each side
and     the door straight up and off the hinges.
NOTE:

● 

Be careful not to place hands between the hinge and

the oven door frame as the hinge could snap back
and pinch fingers.

● 

While working in the oven area, cover the hinges

with towels or 

 paper towel rolls to prevent

pinched fingers and chipping the porcelain enamel
on the frame.

To replace the door,  make sure the hinges are in the
special stop position. Position the slots in the bottom
of the door squarely over the hinges. Then lower the
door slowly and evenly over both hinges at the same
time. If 

 snap back against the oven frame, pull

them back out.

TO CLEAN THE DOOR:
Inside of tbe door:

● 

Because the area inside 

 gasket is cleaned during

the self clean cycle, you do not need to clean this by
hand. Any soap left on the liner causes additional
stains when the oven is heated.

● 

The area outside the gasket can be cleaned with a

scouring pad.

● 

Do not rub or clean the door gasket—the fiberglass

material of the gasket has an extremely low
resistance to abrasion. An intact and well-fitting
oven door gasket is essential for energy-efficient
oven operation and good baking results.   you
notice the gasket becoming worn, frayed or damaged
in any way or if it has become displaced on 

 door,

you should have it replaced.

NOTE: The gasket is designed with a gap at the
bottom to allow for proper air circulation.

 

Gasket

—

Outside Gasket

● 

Use soap and water to thoroughly clean the top,

sides and front of the oven door. Rinse well. 
may also use a glass cleaner to clean the glass on the
outside of the door.

● 

Spillage of marinades, fruit juices, tomato sauces

and basting materials containing acids may cause
discoloration and should be wiped up immediately.
When surface is cool, clean and rinse.

● 

Do not use oven cleaners, cleansing powders or

harsh abrasives on the outside of the door.