Smeg LSA4551B Manuel D’Utilisation

Page de 32
User instructions
16
To set the delay once the program has started, proceed as follows.
If the program you wish to carry out is the same as the one already in progress:
• press 
the 
START/PAUSE  button (4) for a few seconds, until the PROGRAM PHASES lights
(8) come on;
•  annul the program in progress (see relative section) and wait for the cycle to come to an end;
•  select the program again;
•  select the delay required;
• press 
the 
START/PAUSE button (4) to start the new program.
If the program you wish to carry out is different from the one already in progress:
• press 
the 
START/PAUSE  button (4) for a few seconds, until the PROGRAM PHASES lights
(8) come on;
•  change the program;
•  select the delay required;
press the START/PAUSE button (4) to start the new program. The dishwahser will pump out
the water and restart with the delay set and the new program.
TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT
Always try to run the dishwasher fully loaded.
Do not wash the dishes in running water.
Use the washing program that is most appropriate for each type of load.
Do not carry out any preliminary rinsing.
If available, connect the dishwasher to a hot water supply up to 60°C.
When possible, skip the drying cycle by leaving the door open when the washing cycle is
complete; the air and the residual heat will dry the dishes perfectly.
TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT
The phosphates contained in dishwasher detergents are harmful to the environment. To avoid
using excessive amounts of detergent and to save on electricity, observe the following:
separate the more delicate items from dishes that are more resistant to aggressive detergents
and high temperatures;
do not pour  the detergent directly on the dishes.