GE Monogram GFK-1115 Manuel D’Utilisation

The Genius protocol driver is copied to your computer as part of the standard PCS installation
(PCS version 1.8 or later). The PCS should be installed according to the instructions in the
following sections.

Insert the PCS distribution diskette into the appropriate floppy disk drive. If you are using the two
3 1/2” diskettes, install the #1 disk first (the system will prompt you when it is time to insert disk
#2).

Depending on the floppy drive designation (a or b), type one of the following commands at the
DOS prompt, then press the 

↵

↵

 (Enter) key:

or

After you press 

↵

↵

 , the setup program is called and the menu for language selection appears on the

screen.

The Language Selection menu is used to select the language (English or German/Deutsch) in
which you wish to configure the PCS during the installation procedure. This language is used as
the default selection for the PCS.

Press the function key that corresponds to the desired language. When it has been selected, the
Install Program menu is displayed on the screen.