GE Monogram GFK-1115 Manuel D’Utilisation
3 - 4
PANELWARE MMI Application Manual for GE Fanuc Genius Protocol -
June 1995
GFK-1115
3
Screen Configuration
The Screen Configuration menu is displayed once the CONFIG.SYS file changes are made.
This screen allows you to set up the appropriate PCS screen type by pressing the function key that
corresponds to your computer's display. When you select a display type, the system begins copying
the PCS files to the destination directory you selected.
corresponds to your computer's display. When you select a display type, the system begins copying
the PCS files to the destination directory you selected.
After all PCS installation files are copied to the destination directory, the following message is
displayed:
displayed:
Installation completed. Press any key to continue _
The Install Program menu reappears on the screen when any key is pressed.
Note
If the screen type that was selected during installation must be changed after
installation, you can access the Screen Configuration menu again by pressing
F5 Screen configuration from the Install Program menu and selecting the
desired screen type.
installation, you can access the Screen Configuration menu again by pressing
F5 Screen configuration from the Install Program menu and selecting the
desired screen type.
Exiting the Installation
The setup (installation) program is exited when you press F8 EXIT from any of the menus. Before
exiting, the following message will appear on the screen if changes were made to the
CONFIG.SYS file:
exiting, the following message will appear on the screen if changes were made to the
CONFIG.SYS file:
System file modified: RE-BOOT (Y/N)?
To start the PCS properly, it is necessary to reboot the computer after installation when changes
have been made to the CONFIG.SYS file.
have been made to the CONFIG.SYS file.
Remove the distribution diskette from the floppy drive and press
Y
to reboot the computer in order
to put the changes to the CONFIG.SYS file into immediate effect. If you do not remove the
diskette from the floppy drive, the system will reboot from the floppy drive rather than the hard
drive.
diskette from the floppy drive, the system will reboot from the floppy drive rather than the hard
drive.
Caution
During the installation process, a batch file called PANEL.BAT is created
in the root directory of your hard disk. This file should never be deleted,
because it is used to access the PCS.
in the root directory of your hard disk. This file should never be deleted,
because it is used to access the PCS.