Jenn-Air W10665640A Manuel D’Utilisation

■

Your dishwasher is designed to use rinse aid for good drying 
performance. Without rinse aid, your dishes and dishwasher 
interior will have excessive moisture. The heat dry option will 
not perform as well without rinse aid.

■

Rinse aid keeps water from forming droplets that can dry as 
spots or streaks. They also improve drying by allowing water to 
drain off of the dishes after the final rinse.

■

Rinse aid helps to reduce excess moisture on the dish racks 
and interior of your dishwasher.. 

NOTE: For most water conditions, the factory setting will give good 
results. If you have hard water or notice rings or spots, try a higher 
setting. Turn the arrow adjuster inside the dispenser by either using 
your fingers or inserting a flat-blade screwdriver into the center of 
the arrow and turning. 

See “Cycle and Option Descriptions” charts in the following 
section.

Efficient dishwashers run longer to save water and energy, just as 
driving a car slower saves on gas. Typical cycle time is 
approximately 2

¹⁄₂ hours, but can take less or more time to 

complete depending on selections.

See “Cycle and Option Descriptions” charts in the following 
section.

You can customize your cycles by pressing the options desired. If 
you change your mind, press the option again to turn off the option. 
Not all options are available for every cycle. If an invalid option is 
selected for a given cycle, the lights will flash.

NOTE: Run hot water at the sink nearest your dishwasher until the 
water is hot. Turn off water.

■

Push door firmly closed within 3 seconds of 
pressing START/RESUME. If door is not 
closed within 3 seconds, the Start indicator will 
flash, an audible tone will be heard, and cycle 
will not start.

IMPORTANT: If anyone opens the door (such as, for adding a dish, 
even during the Delay Hours option), the Start/Resume button must 
be pressed each time. 

■

Press START/RESUME to repeat the same cycle and options 
as in the previous wash cycle.

■

Check the rinse aid indicator. 
(varies by model) Add rinse aid 
when indicator drops to “Refill” 
level.

■

To add rinse aid, turn the 
dispenser cap to “Open” and 
lift off. Pour rinse aid into the 
opening until the indicator 
level is at “Full.” Replace the 
dispenser cap and turn to 
“Lock.” Make sure cap is fully 
locked

■

On some models, add rinse 
aid by opening the rinse 
dispenser lid by gently 
pushing in the center of the 
lid with your thumb and 
pulling up on the edge. Pour 
rinse aid into the opening 
until the dispenser is full. 
Then, close the dispenser by 
pushing down gently on the 
lid.

Full

Add

¹⁄₄ turn to lock

Lock

Refill

6 5

4

3

2

max

fill

1

- -

-

-

- - -

-

-

-

-

Pre W

as

h

OPEN

S

LIDE