Metrologic Instruments MS9590 Manuel D’Utilisation

 

 

8 

S

CANNER 

I

NSTALLATION

 

“

 
1.  Turn off the host device.  
 
2.  Plug the 10-pin RJ45 end of the 

MVC cable into the 10-pin socket 
on the scanner.  There will be an 
audible click when the connector 
lock engages. 

 
3.  Connect the other end

‹

 of the MVC 

cable to the host device. 

 
4.  Turn on the host device. 
 
5.  The blue LED on the scanner will  

turn on, the white LED will flash, and 
the scanner will beep once. 

 
6.  Scan the bar code below to activate 

the RS485 interface. 

 

³

9

9

9

9

9

5

 

 

USB is the default communication protocol for an MS9590-106 and the 
MS9591-106.  If the recall defaults bar code is scanned after the unit 
has been configured for RS485, the scanner will revert to the USB 
default communication protocol.  The bar code above will need to be 
rescanned to return the unit to the RS485 communication protocol. 

 

The scanner is shipped from the factory configured to set of default 
conditions.  Plugging the scanner into a port on the host system does 
not guarantee that the scanned information will be communicated 
properly to the host device.  The scanner and host device must use the 
same communication protocol.  Please refer to the MetroSelect Single-
Line Configuration Guide or the help files provided with MetroSet2 for 
instructions on changing the scanner’s factory default configuration.  

 

 

“

  Applicable for IBM

®

 host applications 

‹

 

The type of host connection available on an MVC cable is application dependent.  
Contact a customer service representative at 1-800-ID-METRO for additional information 
on the MVC converter cable series.