Metrologic Instruments MS9590 Manuel D’Utilisation

 

 

10 

S

CANNER 

I

NSTALLATION

 

 

 
1.  Turn off the host system.  

 

2.  Plug the 10-pin RJ45 end of the 

cable into the 10-pin socket on the 
scanner.  There will be an audible 
click when the connector lock 
engages. 

 
3.  Plug the other end of the cable into 

the host's keyboard port 

 

If the scanner is receiving power from the 
host system, skip to step #6.  

 

4.  Plug the power supply into the 

power jack on the PowerLink cable.  

 

 

Check the AC in input 
requirements of the power 
supply to verify the voltage 
matches the AC outlet.   
The outlet must be located 
near the equipment and be 
easily accessible. 

 

5.  Connect AC power to the transformer. 

 

6.  Turn on the host device. 
 

The scanner is shipped from the factory configured to set of default  
conditions.  Plugging the scanner into a port on the host system does not 
guarantee that the scanned information will be communicated properly to the 
host device.  The scanner and host device must use the same communication 
protocol.  Please refer to the MetroSelect Single-Line Configuration Guide or the 
help files provided with MetroSet2 for instructions on changing the scanner’s 
factory default configuration. 
 
Powering the MS9590-47 or the MS9591-47 directly from the host device may 
cause interference with the operation of the scanner or the host device.  Not all 
host devices supply the same current through the keyboard port.  Contact a 
Metrologic, customer service representative for information on available external 
power supplies.