Metrologic Instruments IS3480 Manuel D’Utilisation

 

 

8 

I

NSTALLATION

 

 

 

1.  Turn off the host device. 

2.  Plug the male 10-pin RJ45 end of 

the PowerLink cable into the 10-pin 
socket on the IS3480.  

3.  Disconnect the keyboard from the 

host device. 

4.  Connect the “Y” end of the PowerLink 

cable to the keyboard and the 
keyboard port on the host device. 
If necessary, use the male/female 
adapter cable supplied with the 
scanner for proper connections. 

5.  Plug the external power supply into 

the power jack on the PowerLink 
cable.  

Check the AC input 
requirements of the power 
supply to make sure the 
voltage matches the AC 
outlet.  The outlet must be 
located near the equipment 
and be easily accessible. 

 
6.  Connect AC power to the transformer. 

7.  Turn on the host device. 

When the scanner first receives power, the blue LED will turn on; the 
scanner will simultaneously beep once and flash the white LED. 

 

Powering the IS3480 directly from the host device can sometimes cause 
interference with the operation of the scanner or the computer.  Not all 
computers supply the same current through the keyboard port.  For this 
reason, Metrologic recommends using an external power supply.  For 
additional information, contact a Metrologic customer service representative. 

 

Caution:  

 

To maintain compliance with applicable standards, all circuits connected to the scanner 
must meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 
60950.  

 

To maintain compliance with standard CSA C22.2 No. 60950/UL 60950 and norm 
EN/IEC 60950, the power source should meet applicable performance requirements for 
a limited power source.