Metrologic Instruments MS9590i Manuel D’Utilisation

 

 

11

S

CANNER 

I

NSTALLATION

 

 

‹

1.  Turn off the host system. 
 
2.  Plug the 10-pin RJ45 end of the 

USB cable into the 10-pin socket 
on the scanner.  There will be an 
audible click when the connector 
lock engages. 

 
3.  Plug the USB Type A end of the 

cable into the host's USB port. 

 
4.  Turn on the host device. 

 
 
 
 

 

 

USB is the default communication protocol for the MS9590i-106 and the 
MS9591i-106.  The -106 interface models have USB Keyboard Emulation Mode 
enabled by default when shipped from the factory.  
 
The -106 interface models are configurable for Bi-Directional Serial Emulation 
mode and IBM OEM. 
 
Refer to the USB section in the MetroSelect Single-Line Configuration Guide 
(

MLPN

 00-02544) for USB configuration bar codes. 

 

The scanner is shipped from the factory configured to set of default conditions.  
Plugging the scanner into a port on the host system does not guarantee that the 
scanned information will be communicated properly to the host device.  The 
scanner and host device must use the same communication protocol.  Please 
refer to the MetroSelect Single-Line Configuration Guide or the help files 
provided with MetroSet2 for instructions on changing the scanner’s factory 
default configuration.   

 

 

‹

  The -106 scanner interface meets the requirements for Full Speed USB hardware.  

These interfaces also support all emulation types previously supported by Metrologic in 
Low Speed USB scanners.