Metrologic Instruments MS9590i Manuel D’Utilisation

 

 

9

S

CANNER 

I

NSTALLATION

 

 

 

1.  Turn off the host device. 

 

2.  Plug the 10-pin RJ45 end of the cable 

into the 10-pin socket on the scanner.  
There will be an audible click when the 
connector lock engages. 

 

3.  Disconnect the host device's keyboard. 

 

4.  Connect the "Y" ends of the cable to 

the keyboard and keyboard port on the 
host device.  If necessary, use the 
male/female adapter cable supplied 
with the scanner cable to make the 
proper connections. 

 

If the scanner is receiving power from the 
host system, skip to step #7.  

 

5.  Plug the power supply into the power 

jack on the PowerLink cable.  

 

 

Check the AC in input 
requirements of the power supply 
to verify the voltage matches the 
AC outlet.  The outlet must be 
located near the equipment and 
be easily accessible. 

 

6.  Connect AC power to the transformer. 

 

7.  Turn on the host device. 

 

The scanner is shipped from the factory configured to set of default  
conditions.  Plugging the scanner into a port on the host system does not 
guarantee that the scanned information will be communicated properly to the 
host device.  The scanner and host device must use the same communication 
protocol.  Please refer to the MetroSelect Single-Line Configuration Guide or the 
help files provided with MetroSet2 for instructions on changing the scanner’s 
factory default configuration. 
 
Powering the MS9590i-47 or the MS9591i-47 directly from the host device may 
cause interference with the operation of the scanner or the host device.  Not all 
host devices supply the same current through the keyboard port.  Contact a 
Metrologic, customer service representative for information on available external 
power supplies.