Metrologic Instruments MS9590i Manuel D’Utilisation

 

 

5

I

NTRODUCTION 

 

 

Important:  If the cable is not fully latched, the unit can power intermittently. 
 

 

 

1.  Plug the 10-pin RJ45 end of the cable into the 10-pin socket on the scanner.  

There will be an audible click when the connector lock engages. 

2.  Gently pull on the cable strain relief to insure the cable is securely installed. 
 

 

Before removing the cable from the scanner, Metrologic recommends that power 
to the host system be turned off.  If the cable is a PowerLink cable, disconnect 
the power supply on the cable.  
 

 

 
1.  Locate the small dimple on the handle of the unit near the cable connection. 
2.  Bend an ordinary paperclip into the shape shown above in Figure 3. 
3.  To release the cable lock, push the end of the paperclip through the rubber 

on the handle where the dimple is located.  

4.  There will be an audible click when the connector lock releases.  Pull gently 

on the strain-relief of the cable to separate the cable from the scanner.