Metrologic Instruments MS9590i Manuel D’Utilisation

 

 

7

S

CANNER 

I

NSTALLATION

 

 

1.  Turn off the host device.  

 

2.  Plug the 10-pin RJ45 end of the 

PowerLink cable into the 10-pin 
socket on the scanner.  There will be 
an audible click when the connector 
lock engages. 

 
3.  Connect the 9-pin D-type connector 

of the PowerLink cable to the proper 
COM port on the host device. 

 

If the scanner is receiving power from the 
host system, skip to step #6.  
 
4.  Plug the power supply into the power 

jack on the PowerLink cable.  

 

 

Check the AC in input 
requirements of the power 
supply to verify the voltage 
matches the AC outlet.   
The outlet must be located 
near the equipment and be 
easily accessible. 

 
5.  Connect AC power to the transformer. 
 
6.  Turn on the host device. 

The scanner is shipped from the factory configured to set of default 
conditions.  Plugging the scanner into a port on the host system does 
not guarantee that the scanned information will be communicated 
properly to the host device.  The scanner and host device must use the 
same communication protocol.  Please refer to the MetroSelect Single-
Line Configuration Guide or the help files provided with MetroSet2 for 
instructions on changing the scanner’s factory default configuration.