Metrologic Instruments MS7320 Manuel D’Utilisation

NSTALLATION FOR

RS232

IGHT

NTERFACES

1. Turn off the host system.

2. Connect the PowerLink cable to the

10-pin RS232/Light Pen interface

jack. It is the 1

round opening from

the left side of the MS7320

(see figure 5).

3. Connect the other end of the

PowerLink cable to the host.

Before continuing verify that the

PowerLink cable is connected to the

appropriate interface jack on the

scanner. An incorrect cable connection

can cause communication problems or

potential damage to the scanner.

4. Connect the external power supply to

the power jack on the PowerLink

Cable.

5. Check the AC input requirements of

the power supply to make sure the

voltage matches the AC outlet.

6. Connect AC power to the

transformer. The outlet should be

near the equipment and easily

accessible.

7. Scan the appropriate bar codes on

page 9 to configure the MS7320 for

RS232 or Light Pen communication.

8. Turn on the host system.

9. Snap on the cable cover.

See SELV Power Source caution statement located on page 16 of this manual.

Figure 5: RS232 or

Light Pen Interface