Barco SJ/T 11363-2006 Manuel D’Utilisation
PDS • User’s Guide
105
6. Upgrading Firmware
Upgrading Firmware Using the Web Upgrade
qêçìÄäÉëÜççíáåÖ=bíÜÉêåÉí=`çããìåáÅ~íáçå
Use the following steps to determine the IP address of the PDS, and establish proper
communications:
communications:
1.
Power-up the PDS.
2.
Note the PDS’s current IP address:
a.
From the Status Menu, press SEL to display the Setup Menu.
b.
Select System to display the System Menu.
c.
Select Ethernet to display the Ethernet Menu.
d.
Make a note of the information on the IP line, which shows the current IP
address in all modes (with DHCP on or off).
address in all modes (with DHCP on or off).
3.
Attempt to ping the PDS as follows:
a.
Connect the PDS’s Ethernet port to a Switch.
b.
Connect the Ethernet Switch to your PC.
c.
Turn on the PC or laptop.
d.
Open a command prompt window on the PC. Click Start > Programs >
Accessories > Command Prompt
Accessories > Command Prompt
.
e.
On the command prompt line, type:
ping 192.168.0.10
... followed by Enter.
f.
If the computer can successfully communicate with the PDS, you will see
a series of “replies” from the target IP address. Repeat the upgrade
procedure as outlined in the “
a series of “replies” from the target IP address. Repeat the upgrade
procedure as outlined in the “
” section on page 100.
g.
If you see a “Request timed out” message, the PC is unable to locate
the PDS. If this is the case:
the PDS. If this is the case:
•
Check your network connections and settings as described
above, or,
above, or,
•
Contact your network administrator, or,
•
” section on page 174 for details.
Note
Use the unit’s actual IP address, as determined in step 2
above.
above.