Q-Logic 16HA Manuel D’Utilisation
Preliminar
y
Cable Fibre Channel Devices to the Switch
SANbox-16HA Fibre Channel Switch
Installer’s/User’s Manual
59005-03 Rev. A
Installation
2-9
Private devices connect to Segmented Loop Ports (SL_Ports) or Translated Loop
Ports (TL_Ports). Use Switch Management to configure SL or TL_Ports. Refer to
Ports (TL_Ports). Use Switch Management to configure SL or TL_Ports. Refer to
for a description of SL and TL_Ports. Refer to
.
Mixing Public and Private Devices on the Same Loop.
You may place a Private device on a Public loop but the Private device will not be
able to communicate outside the loop.
able to communicate outside the loop.
You may place a Public device on a Private loop but the Public device functions as
a Private device.
a Private device.
Switch Ports
Any Fibre Channel port on the Switch may be an FL_Port, SL_Port, TL_Port, or a
T_Port. Refer to
T_Port. Refer to
for a description of T_Ports. The
type of media used (fiber optic cable or copper) depends on the type of Fibre
Channel adapter in the attached device and the type of GBICs used in the Switch.
You may populate the Switch with any assortment of approved GBICs appropriate
for your interconnection media type.
Channel adapter in the attached device and the type of GBICs used in the Switch.
You may populate the Switch with any assortment of approved GBICs appropriate
for your interconnection media type.
Tuning
You can optimize the system performance by connecting devices which have the
greatest amount of traffic to ports on the Switch which are most efficiently inter-
connected.The most efficient performance is within a group of four ports on the
same Application-Specific-Integrated-Circuit (ASIC). These groups are:
greatest amount of traffic to ports on the Switch which are most efficiently inter-
connected.The most efficient performance is within a group of four ports on the
same Application-Specific-Integrated-Circuit (ASIC). These groups are:
•
Ports 1-4
•
Ports 5-8
•
Ports 9-12
•
Ports 13-16
When a frame source-port and destination-port are within the same port group, you
will realize:
will realize:
•
The lowest Class 2/Class 3 frame latency
•
The highest Class 2/Class 3 point-to-point bandwidth
•
The highest Class 2/Class 3 aggregate bandwidth
When a frame source-port and destination-port are not within the same port group
the interconnection is slightly less efficient.
the interconnection is slightly less efficient.