Q-Logic 59226-00 B Manuel D’Utilisation

A – Command Line Interface

Set Setup Command

59226-00 B

A-57

A

Changes SNMP and system configuration settings. The switch maintains one 
SNMP configuration and one system configuration.

Admin session

snmp
system

Prompts you in a line-by-line fashion to change SNMP configuration settings. 

 describes the SNMP fields. For each parameter, enter a new value or 

press the Enter key to accept the current value shown in brackets.

SNMPEnabled

Enables (True) or disables (False) SNMP on the switch. The 
default is True.

Contact

Specifies the name of the person to be contacted to respond to 
trap events. The name can be up to 64 characters excluding #, 
semicolon (;), and comma (,). The default is undefined.

Location

Specifies the name of the switch location. The name can be up 
to 64 characters excluding #, semicolon (;), and comma (,). 
The default is undefined.

Trap [1-5] Address

Specifies the workstation IP address to which SNMP traps are 
sent. The default address for trap 1 is 10.0.0.254. The default 
address for traps 2–5 is 0.0.0.0. Addresses, other than 0.0.0.0, 
for all traps must be unique.

Trap [1-5] Port

Specifies the workstation port to which SNMP traps are sent. 
Valid workstation port numbers are 1–65535. The default is 
162.

Trap [1-5] Severity

Specifies the severity level to use when monitoring trap events. 
The default is Warning

Trap [1-5] Version

Specifies the SNMP version (1 or 2) to use in formatting traps. 
The default is 2.

Trap [1-5] Enabled

Specifies whether traps (event information) are enabled or dis-
abled (default).