Справочник Пользователя для Q-Logic 59226-00 B
A – Command Line Interface
Set Setup Command
59226-00 B
A-57
A
Set Setup Command
Changes SNMP and system configuration settings. The switch maintains one
SNMP configuration and one system configuration.
SNMP configuration and one system configuration.
Authority
Admin session
Syntax
set setup
snmp
system
system
Keywords
snmp
Prompts you in a line-by-line fashion to change SNMP configuration settings.
describes the SNMP fields. For each parameter, enter a new value or
press the Enter key to accept the current value shown in brackets.
Table A-13. SNMP Configuration Settings
Entry
Description
SNMPEnabled
Enables (True) or disables (False) SNMP on the switch. The
default is True.
default is True.
Contact
Specifies the name of the person to be contacted to respond to
trap events. The name can be up to 64 characters excluding #,
semicolon (;), and comma (,). The default is undefined.
trap events. The name can be up to 64 characters excluding #,
semicolon (;), and comma (,). The default is undefined.
Location
Specifies the name of the switch location. The name can be up
to 64 characters excluding #, semicolon (;), and comma (,).
The default is undefined.
to 64 characters excluding #, semicolon (;), and comma (,).
The default is undefined.
Trap [1-5] Address
Specifies the workstation IP address to which SNMP traps are
sent. The default address for trap 1 is 10.0.0.254. The default
address for traps 2–5 is 0.0.0.0. Addresses, other than 0.0.0.0,
for all traps must be unique.
sent. The default address for trap 1 is 10.0.0.254. The default
address for traps 2–5 is 0.0.0.0. Addresses, other than 0.0.0.0,
for all traps must be unique.
Trap [1-5] Port
Specifies the workstation port to which SNMP traps are sent.
Valid workstation port numbers are 1–65535. The default is
162.
Valid workstation port numbers are 1–65535. The default is
162.
Trap [1-5] Severity
Specifies the severity level to use when monitoring trap events.
The default is Warning
The default is Warning
Trap [1-5] Version
Specifies the SNMP version (1 or 2) to use in formatting traps.
The default is 2.
The default is 2.
Trap [1-5] Enabled
Specifies whether traps (event information) are enabled or dis-
abled (default).
abled (default).