Q-Logic 2-8C Manuel D’Utilisation

B – Command Line Interface

Set Setup Command

59042-06 A

B-51

0

Eth0NetworkMask

Ethernet subnet mask address.

Eth0GatewayAddress

Ethernet IP address gateway.

AdminTimeout

Amount of time in minutes the switch waits before 
terminating an idle Admin session. Zero (0) 
disables the time out threshold. The default is 30, 
the maximum is 1440.

InactivityTimeout

Amount of time in minutes the switch waits before 
terminating an idle SANsurfer Switch Manager 
Web applet session. Zero (0) disables the time out 
threshold. The default is 0, the maximum is 1440.

TempMonitoringWarning

Warning temperature threshold in °C above which 
a warning condition alarm is generated. The 
default is 40 °C.

TempMonitoringFailure

Failure temperature threshold in °C above which a 
failure condition alarm is generated. The default is 
45 °C.

TempFailurePortShutdown

Enables (True) or disables (False) the switch’s 
ability to place all ports down when the internal 
temperature exceeds the failure threshold. The 
default is False. If the temperature exceeds the 
failure threshold, correct the problem, then reset 
the switch to bring the ports back online.

UserAuthentication

Enables (True) or disables (False) the enforcement 
of account names and passwords for SANsurfer 
Switch Manager. Enabling this parameter does not 
affect a logged in account until that account logs in 
again.The default is False.

LocalLogEnabled

Enables (True) or disables (False) the saving of log 
information on the switch. The default is True.

RemoteLogEnabled

Enables (True) or disables (False) the recording of 
the switch event log on a remote host that supports 
the syslog protocol. The default is False.

RemoteLogHostAddress

The IP address of the host that will receive the 
switch event log information if remote logging is 
enabled. The default is 10.0.0.254.