Q-Logic 2-8C Manuel D’Utilisation

4 – Installation

Installing a Switch

59042-06 A

4-17

0

a.

Choose the Start button, select Programs, Accessories, 
HyperTerminal, and HyperTerminal.

b.

Select the connection you created earlier and choose the OK 
button.

„

Serial – Linux: Open a command window and enter the following 
command:

minicom

„

Serial – Solaris: Open a command window and enter the following 
command:

tip sanbox2

2.

Open an admin session and enter the Set Setup System command. Enter 
the values you want for switch IP address (Eth0NetworkAddress) and the 
network mask (Eth0NetworkMask). Refer to 

 for more information about this command.

SANbox2 #> admin start

SANbox2 (admin) #> set setup system

Connect cables to the SFP transceivers and their corresponding devices, and 
then energize the devices. Device host bus adapters can have SFP (or SFF) 
transceivers or GigaBit Interface Converters (GBIC). LC-type duplex fiber optic 
cable connectors are designed for SFP transceivers, while SC-type connectors 
are designed for GBICs. Duplex cable connectors are keyed to ensure proper 
orientation. Choose the fiber optic cable with the connector combination that 
matches the device host bus adapter.