Q-Logic 2-8C Manuel D’Utilisation

4 – Installation
Install Firmware

4-20

59042-06 A

0

331 Password required for username.

Password:

230 User username logged in.

bin

200 Type set to I.

verbose

Verbose mode off.

5.

Enter the following command to display the list of firmware files:

SANbox2 (admin) #> image list

6.

Enter the following command to install the new firmware:

SANbox2 (admin) #>image unpack filename

7.

Review the conditions for a non-disruptive activation on 

 and 

determine whether a non-disruptive activation is possible. Enter the Hotreset 
command to perform a non-disruptive activation. During a non-disruptive 
activation, all Logged-In LEDs are illuminated.

SANbox2 (admin) $>hotreset

If a non-disruptive activation is not possible, a message will prompt you to 
perform a disruptive activation.

SANbox2 (admin) $>reset

To install firmware using the CLI when the management workstation does not 
have an FTP server, do the following:

1.

Connect to the switch through the Ethernet or the serial port.

2.

Move to the folder or directory on the workstation that contains the new 
firmware image file.

3.

Establish communications with the switch using the File Transfer Protocol 
(FTP). Enter one of the following on the command line:

>ftp xxx.xxx.xxx.xxx

or

>ftp switchname

where xxx.xxx.xxx.xxx is the switch IP address, and switchname is the 
switch name associated with the IP address. 

4.

Enter the following account name and password:

user:images

password: images