Q-Logic 2-8C Manuel D’Utilisation
5 – Diagnostics/Troubleshooting
POST Diagnostics
59042-06 A
5-3
0
5.1.1.3
Configuration File System Error Blink Pattern
A configuration file system error blink pattern is 4 blinks followed by a two second
pause. The 4-blink error pattern indicates that a configuration file system error has
occurred, and that the configuration file must be recreated. Refer to
pause. The 4-blink error pattern indicates that a configuration file system error has
occurred, and that the configuration file must be recreated. Refer to
To recreate the configuration file, do the following:
1.
Open a Telnet session and use the Shutdown command to close activity on
the switch, then power down the switch. Refer to the
the switch, then power down the switch. Refer to the
.
2.
Place the switch in maintenance mode. Press and hold the Maintenance
button for 2–4 seconds. Refer to
button for 2–4 seconds. Refer to
for
more information about placing the switch in maintenance mode.
3.
Establish a Telnet session with the switch using the default IP address
10.0.0.1.
10.0.0.1.
telnet 10.0.0.1
4.
Enter the account name (prom) and password (prom), and press the Enter
key.
key.
Sanbox2 login: prom
Password:xxxx
[username@host:Itasca]% telnet 10.0.0.1
Trying 10.0.0.1...
Connected to 10.0.0.1.
Escape character is '^]'.
CAUTION!
Recreating the configuration file will delete all switch configuration
settings.
settings.
2 seconds