Q-Logic MKII-BASE16 Manuel D’Utilisation
1-12
General Description
GigWorks MKII-16 Switch Model MKII-BASE16
59003-01 Rev. A Installer's/User's Manual
General Description
When the overheated power supply cools down, the power supply will
attempt to place itself back in service. If the cause for the overheating
condition is still present, the power supply will eventually overheat again
and the shutdown process will repeat. During the periods where both power
supplies are operating, the Power Supply Fail LED on the front of the
chassis will turn OFF. The Power Supply Fail LED will only be ON when
one of the two power supplies is actually failing.
attempt to place itself back in service. If the cause for the overheating
condition is still present, the power supply will eventually overheat again
and the shutdown process will repeat. During the periods where both power
supplies are operating, the Power Supply Fail LED on the front of the
chassis will turn OFF. The Power Supply Fail LED will only be ON when
one of the two power supplies is actually failing.
Chassis Switch Panel
Refer to Figure 1-4 for the location of the Chassis Switch Panel. The Chassis
Switch panel contains a microprocessor Reset button, switches for bypassing the
Flash memory and Watchdog Timer, and Test Mode select switches. Use these
switches only under the direction of Ancor Customer Service. Refer to the
Chassis Switch Panel appendix for a description of these switches and buttons.
Switch panel contains a microprocessor Reset button, switches for bypassing the
Flash memory and Watchdog Timer, and Test Mode select switches. Use these
switches only under the direction of Ancor Customer Service. Refer to the
Chassis Switch Panel appendix for a description of these switches and buttons.
Switch Management Connector
The Switch Management Connector is an Ethernet 10BASE-T interface that
provides a connection to a management station. The management station, running
the Ancor Switch Utilities or SNMP, provides a means to access such things as
the Fibre Channel Management Information Base (MIB) and upgrade the control
firmware held in the Switch’s Flash memory.
provides a connection to a management station. The management station, running
the Ancor Switch Utilities or SNMP, provides a means to access such things as
the Fibre Channel Management Information Base (MIB) and upgrade the control
firmware held in the Switch’s Flash memory.
Refer to the Switch Management Section of this manual for information about
how to connect the management station and manage the Switch.
how to connect the management station and manage the Switch.