Q-Logic MKII-BASE16 Manuel D’Utilisation

If the installation is in Europe, IEC regulations require that a Class 1 laser
information label be placed where it is clearly visible whenever access to the
optical ports is possible. The drawing below pictures the label.

Remove the paper on the back of the label and apply it to the equipment rack in a
place where it is clearly visible whenever access to the optical ports is possible.

You may populate your Switch with 2 to 16 GBICs. The choice of ports and
GBICs is yours. The Switch has been validated with GBICs that support a variety
of interconnection media.

If you are populating your Switch with 16 GBICs that are all the same media
type, install them by following the instructions in the GBIC Replacement
procedure in the Removal/Replacement Procedures section of this manual.

If you are installing less than 16 GBICs and/or they are a mix of media types,
before you install them, refer to the Tuning paragraphs in Step 7 of this
procedure. The Tuning paragraphs give you information that will allow you to
use the Switch the most efficiently. Then, install them by following the
instructions in the GBIC Replacement procedure in the Removal/Replacement
Procedures section of this manual. 

CLASS 1 LASER PRODUCT

TO IEC 825 (1984) + CENELEC HD 482 S1

LASER KLASSE 1

LUOKAN 1 LASERLAITE

APPAREIL A LASER DE CLASSE 1