Q-Logic MKII-BASE16 Manuel D’Utilisation
3-36
Switch Management
GigWorks MkII-16 Switch Model MKII-BASE16
59003-01 Rev. A Installer's/User's Manual
Switch Utilities — Management Configuration
Management Configuration
Figure 3-12 Management Configuration Tab
Refer to Figure 3-12. The Management Configuration tab enables you to
configure the Ethernet port of the Switch to-which the management station is
connected.
configure the Ethernet port of the Switch to-which the management station is
connected.
IP Network Configuration
Use the IP Network Configuration area of this screen to read, modify, or write the
Switch Management port IP Address information.
Switch Management port IP Address information.
Get IP Config. Button: Press to read the IP information displayed in the fields
to the Right of the button.
to the Right of the button.
Set IP Config. Button: Press to write the IP information, displayed in the fields
to the Right of the button, into the Switch. This new IP Address information will
not take affect until the Switch is re-booted or the management firmware is reset
using one of the Reset buttons on the bottom of this screen.
to the Right of the button, into the Switch. This new IP Address information will
not take affect until the Switch is re-booted or the management firmware is reset
using one of the Reset buttons on the bottom of this screen.
You may also set the Switch to read its IP Network Configuration from a BootP
server by checking the “Use BootP” box. This tells the Switch to use BootP the
server by checking the “Use BootP” box. This tells the Switch to use BootP the