Q-Logic 5802V Manuel D’Utilisation

14 – Command Reference

Test Port

14-196

59263-01  A

S

 describes the port test parameters.

To cancel a port test that is in progress, enter the 

 Port command.

To display the status of the most recent port test or port test in progress, enter the 

 Port command.

The following example performs an online test on port 1:

SANbox #> admin start

SANbox (admin) #> test port 1 online

A list of attributes with formatting and current values will follow. Enter a new 

value or simply press the ENTER key to accept the default value. If you wish to 

terminate this process before reaching the end of the list press 'q' or 'Q' and the 

ENTER key to do so.

LoopCount     (decimal value, 1-4294967295)   [429496729]

FrameSize     (decimal value, 40-2148)        [256      ]

DataPattern   (32-bit hex value or 'Default') [Default  ]

StopOnError   (True / False)                  [True     ]

LoopForever   (True / False)                  [False    ]

Do you want to start the test? (y/n) [n] y

The test has been started.

A notification with the test result(s) will appear

on the screen when the test has completed.

SANbox (admin) #>

  Test for port 1 Passed.

LoopCount

Number of frames sent

FrameSize

Number of bytes in each test frame

DataPattern

Pattern in the payload

StopOnError

Stops the test when an error occurs (True). 
Otherwise, the test continues to comple-
tion.

LoopForever

Restarts the test after completion and con-
tinues until you cancel it (True). Otherwise, 
the test ends normally after completion.