Alpha Vision Tech MPS48-7M Manuel D’Utilisation
14
021-511-B4-002, Rev. B
4.0 Installation
4.1 Unpacking the MPS48-7M
Remove the mounting bracket and enclosure from the
shipping carton. Inspect the MPS48-7M for shipping
damage.
shipping carton. Inspect the MPS48-7M for shipping
damage.
Verify each carton contains:
• MPS48-7M
enclosure
•
Mounting bracket and hardware
•
3/4" 3-hole strain relief fi tting
•
1/2" strain relief fi tting
• Cable
ties
•
Quick Start Guide
4.2 Enclosure Installation, Wall-mount or Wooden Pole-mount
Most codes require the base of the enclosure to be located a minimum height from the
ground. Always verify height restrictions before installation.
ground. Always verify height restrictions before installation.
Before installing an enclosure, the location and method of mounting must be approved by the property owner.
ATTENTION:
Recommended Tools and Materials:
•
Ratchet with 7/16" socket
• Level
• Phillips
• Phillips
screwdriver
•
Two user-supplied 1/4" x 2-1/2" (7mm x 60mm) lag bolts with fl at washers
• Stud
fi nder (optional)
Installation Procedure:
1. Remove the mounting hardware from the inside of the bracket
and position the bracket on a wall or wooden pole capable of
supporting 35 lb. (16kg). Use a backing plate if necessary.
supporting 35 lb. (16kg). Use a backing plate if necessary.
2. Level the bracket vertically with the tab facing up.
3. Secure the bracket to the wall or pole using two user-supplied
1/4" x 2-1/2" lag bolts. The hardware must sit fl ush inside the
bracket dimples for proper installation.
bracket dimples for proper installation.
Lag Bolt
Lag Bolt
Tab